The Andino IO is a motherboard for the Raspberry Pi. It allows mounting on a DIN rail in the control cabinet.
The setup documentation section can be found at the bottom!
The Andino IO is a microcontroller board for the Raspberry Pi in a DIN-rail housing for installation in a control cabinet. It is used to adapt digital inputs and outputs for a voltage of 24 V. It also contains a Raspberry Pi. The inputs and outputs as well as the power supply of the Pi are optimally protected. Communication between the microcontroller and the Pi takes place via the UART interface.
For a general introduction on the Andino IO board, see Andino IO
The external 4G modem is connected via USB. Using an LTE connection it can be used for high speed data transmission at a speed of up to 300 Mbit/s. It can also be used to send and receive SMS messages.
Before the 4G/LTE modem was connected as an external device that could be installed next to the Andino IO, it was directly integrated into the IO housing, necessitating the opening of the case to install the sim card. To find out how to open the housing, please follow the description in this video:
- Andino IO: BaseBoard Setup
- How to set up the 4G modem via qmi
- How to set up the 4G modem via ppp (not recommended for data transfer)
- How to send / receive SMS
- 2020 by AndinoSystems
- Contact us by email